Martin Tools -Body Spoons

Heavy Duty Double End S-Spoon Part M1044

• General purpose fender and frame spoon.
• Designed to provide further reach on panels and behind reinforcements.
• Prying, heavy duty designed for use on SUV frames.
• 12 3/16″ Length.
• 1 3/8″ x 2 1/4″ face.
• Weight 2.1 lbs.

• Long slender shape just like the 1024 surfacing spoon.
• Inside with medium crown, for high ridges or prying.
• For slapping and surface finishing on fenders, panels and trunk lids.
• Blade fully polished.
• 9″ Blade Length.
• 2 1/8″ Width.
• Overall Length 14 7/8″.
• Weight 2.5 lbs.

• Excellent spoon for fender spring hammering, finishing and shaping.
• Curve gets behind inner construction between panels that are close for removal of  dents.
• Molds panels.
• Blade fully polished.

• Useful for restoration of turned under,  non-wired flanged edges.
• Also handy for alignment of inner construction and flanges on alligator hoods.
• Heavy formed striking pads.

• Long, thin, curved blade is handy for prying up dents behind curved reinforcements in header panels, hinge anchors in doors, body pillars and reinforcements in hoods and radiator shells.

• Long handle permits many uses in places otherwise inaccessible.
• Can be driven between reinforcements and outer panel, then used to pry outward as the metal is  dinged.
• Excellent forming and caulking tool for deep pockets of doors, quarter-
  panels, rear fenders and lower trunk panels.

• General purpose fender spoon.
• Used as dolly behind brackets, inner panels and similar places.
• Handle offset to give balance when dinging and for long reach.
• Has high-crown working surface.

• To ding ridges smooth and level.
• When held against ridge and struck with hammer, spreads blow over large area making smooth job and preventing damage to metal or finish.
• Not made for prying.
• Length 10″ overall.